Kreta 215 ML DEKTON® Pre-dosed Adhesive

215 ML Kreta Mastidek Adhesive for DEKTON® Kreta Surfaces

For use in working with DEKTON® Kreta surfaces in indoor and outdoor settings.

Mastidek Kreta Cartridge Glue for use on Cosentino DEKTON® Kreta is a new generation bi-component resin. Mastidek Kreta glue has a very high adhesion in a short amount of time which allows for cutting and polishing the assembled parts in approximately 45-60 minutes. The hardened product is very shiny and is very polishable.

Kreta is produced in special cartridges with a 2:1 bi-axial quantity 215 ml. The glue and hardener are pre-dosed in the cartridge. Once inserted in the proper gun, with the special mixer fixed on top, the cartridge allows the correct extrusion and mixing of the 2 parts. Kreta cartridges require the use of a special M200XMR Cartridge Gun. Kreta cartridge glue is suitable for outdoor use.

Directions for Using Kreta:

Kreta is effective for the intended use only when it is used properly. Please be sure to acquaint yourself with how to use and store the adhesive and how to prepare the surface before use. The directions for using Mastidek Kreta are as follows:

1. Clean all surfaces to remove dust and grease.
2. For polished or glossy surfaces, scrub the surface with sandpaper before gluing.
3. Remove cap and attach the special threaded mixing nozzle.
4. Squeeze out about 6" of product before applying to surface.
5. Apply the adhesive to the surface being bonded.
6. Clean the nozzle after use, replace the cap and discard the mixing nozzle.
7. Repeat steps 3-6 at any change of the mixer.
8. After usage, clean the nozzle, replace the cap and discard the mixer after.
9. Product will not set below 32°.

Kreta Shelf Life:

The product in the cartridge will last at least 12 months if stored between 65° and 77°. Keep away from sunlight, heat and humidity.

Safety:

Please read the Kreta Safety Data Sheet and B Part Safety Data Sheet before use and follow the product instructions.